ACTi ENR-140 Installation Guide download pdf (Page 22)

www.acti.com

ENR-100 Series System Administrator’s Manual

Install the Hard Disks

This system requires at least one hard disk to store video recordings and firmware image

when upgrading system. Please follow the instructions below to install your hard disks in

correct order to make sure the physical disk locations accord with the Disk ID shown in ENR

server’s Storage Device List.

ENR-110/120/130

Step 1 Remove the Case Cover

Remove the four front

panel screws, and then

remove the three back

panel screws.

Slide the case backward

until it stops, and then lift it

up to remove.

Step 2 Install Disk SATA-2

Insert Disk SATA-2 in the

lower bay, connect SATA

power cable and SATA

data cable 2 to the hard

disk.

Make sure you connect the

correct data cable to the

corresponding disk.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 138 139

No comments

ACTi ENR-140 Installation Guide Page 22