ACTi ENR-140 Installation Guide download pdf (Page 127)

www.acti.com

ENR-100 Series System Administrator’s Manual

127

Disk Management

ENR keeps the recordings on SATA hard disks installed in it. Whenever recording is taking

place, ENR writes data to one of the disks, and switch to the other as the original one is full.

Once the available space of the whole system is less than the reserved size, ENR will start

deleting the oldest file to make the amount of space allowing each active channel to record

for another 10 minutes.

You may observe the disk memory and recording status on Storage page.

Go to Setup page  System tab Storage. The connected storage devices will be shown

in the Storage Device list.

Format Hard Disks

Select a disk and click “Format”.

You may execute disk formatting toward a newly-installed disk. You should follow the

installation procedures (refer to Install the Hard Disks on page 22 ) to format the disks before

ENR system start carrying out the surveillance task, for a disk that is not in ENR file system

format is not ready for recording. Please note that the system will stop recording during the

disk formation.

If you have to format a disk having been recording for a while, it is suggested that you export

important video and system log in advance.

1 2 ... 122 123 124 125 126 127 128 129 130 131 132 ... 138 139

No comments

ACTi ENR-140 Installation Guide Page 127