ENR-100 Series System Administrator’s Manual
24
ENR-140
Please follow the instructions below to install your hard disks in correct order to make sure
the physical disk locations accord with the Disk ID shown in ENR server’s Storage Device
List.
To start, TURN OFF THE DEVICE, open the front
cover, repeat the following steps to install the hard
disks into the disk bays.
Step 1 Remove the Tray
Slide the Lock Tab to the right, the Hinge Tab will
pop out by itself. Remove the four front panel screws,
and then remove the three back panel screws.
Pull the Hinge Tab to 90 degrees from the front, and
pull out the tray.
Comments to this Manuals