ACTi ENR-140 Installation Guide download pdf (Page 95)

www.acti.com

ENR-100 Series System Administrator’s Manual

Configure Network Settings

There are two network interface cards in ENR.

Either of these cards can be supported by the built-in DHCP server feature, which enables

ENR to assign IP addresses to cameras via LAN1 or LAN2 port without another DHCP on

router.

By default, LAN1 card uses a fixed IP address 192.168.0.10, while LAN2 is in DHCP client

mode. It is suggested that you connect LAN1 to LAN and connect LAN2 to WAN.

Current IP Configurations

Go to Setup page  Network tab.

IP Settings

On Network tab, click “Network Connection” then select the interface card that you wish to

set up. After setting up, please click “Save” on the bottom right side to save the settings.

LAN1 Configuration LAN2 Configuration

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 138 139

No comments

ACTi ENR-140 Installation Guide Page 95