ACTi ENR-140 Installation Guide download pdf (Page 47)

www.acti.com

ENR-100 Series System Administrator’s Manual

After selecting the camera, click “Motion Detection Settings”. If this camera is in dual

stream mode, only Channel ID 1 (Stream 1) supports motion detection feature. On Motion

Detection Settings window, check “Enable” then click “Motion Setup”. To enable one

motion region, check it, a color frame will appear in the view. You may start setting the

detection area by adjusting this yellow frame on the view. Simply use your mouse to move

and resize the frame. Click “Apply” to save the settings.

Field Name

Description

Sensitivity

(0-100%)

Determines how sensitive the camera reacts to the movement. The higher the

sensitivity level is, the smaller motion will trigger the alarm, but may give false

alarms. Default is 70%.

Timer

(0-300 secs)

The interval before the next motion detection can be triggered again.

Default is 1 second.

Threshold

(0-100%)

The threshold level of this motion detection region. The lower threshold level

is, smaller portion of the region would be considered as motions, which is

more easily to be triggered, but may give more false alarms.

Default is 10%.

To move the entire frame

Place the mouse cursor over the

title bar, and drag to move.

To adjust the region dimension

Place the mouse cursor over the

bottom right corner, and drag to

resize.

To disable this

detection region

Place the mouse cursor

over the upper right

corner, and click the “x”

to close this frame.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 138 139

No comments

ACTi ENR-140 Installation Guide Page 47