ACTi ENR-140 Installation Guide download pdf (Page 53)

www.acti.com

ENR-100 Series System Administrator’s Manual

IP Settings

Go to Setup page  Network tab  click “Network Connection” and select the LAN

interface card that you wish to set up. After setting up, please click “Save” on the bottom right

to save the settings.

Field Name

Description

Connection Type

Choose one connection type for this LAN port. DHCP and PPPoE

service will assign an IP Address to ENR, and there is no need for

you to define other network information.

Manual: Please obtain a static IP address and other network

information including Subnet Mask, Gateway and DNS server from

your network administrator.

DHCP: Use this connection type if you have a DHCP server on your

network router.

PPPoE: Chose this when your ISP is using PPPoE type DSL line.

Please contact you ISP to get the Username and Password for this

connection.

LAN1 default is Manual; LAN2 default is DHCP.

IP Address

Fixed IP Address. LAN1 default is 192.168.0.10; LAN2 default is

Auto.

LAN Connection Status

Shows “Activated” when connected to a network.

Shows “Detected Network Cable Disconnection” when not connected to a network

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 138 139

No comments

ACTi ENR-140 Installation Guide Page 53