ACTi E66 Installation Guide download pdf (Page 19)

E-19

• If the power supply voltage exceeds the PS-A unit's range, connect a

voltage transformer.

• Between the line and the ground, be sure to use a low noise power supply.

If there is still an excessive amount of noise, connect a noise reducing

transformer.

Be sure any constant or insulating transformer used has a capacity of

200VA or more.

7 Power Supply Cautions

Please pay special attention to the following instructions when connecting

the AC Connector to the PS-A unit.

3) Insert the Cord Clamp Lock Pin into the PS-A’s Lock Pin Hole.

4) Adjust the Lock Pin’s Lock Tab length until it is securely held.

 

 Removing the AC Power Cord

1) While lifting up on the Lock Pin’s Lock Tab Release, pull the AC Plug, Plug Collar and Cord

Clamp backwards to disconnect it from the PS-A.

2) Open the Cord Clamp and remove the AC Power Cord from the Cord Clamp.

Figure 2

Cord Clamp Lock Pin

Lock Pin Hole

Lock Tab Release

Cord Clamp

AC Plug

AC Plug Collar

2) Connect the AC plug to the PS-A’s AC connector, as shown in fig. 2.

AC Connector

1 2 ... 14 15 16 17 18 19 20

No comments

ACTi E66 Installation Guide Page 19