ACTi E66 Installation Guide download pdf (Page 18)

E-18



 Installing the AC Power Cord Clamp

• Be sure to connect the power cord only after confirming that the

PS-A unit rear face power switch is turned OFF.



Attaching the AC Power Cord

1) Open the AC Power Cord Clamp and insert the AC Power Cord as shown in fig. 1. Then,

close the Cord Clamp until it clicks into place and locks around the AC Power Cord Collar.

• The Cord Clamp has four teeth for locking. These are to adjust the amount of

grip used to hold the AC Power Cord Collar.

Figure 1

AC Plug Collar

AC Plug

Cord Clamp

6 Wiring

• To avoid an electric shock, check that the PS-A's power supply is

turned OFF, via a breaker, or similar unit before connecting the

PS-A's power cord to the AC connector.

• To avoid the dangers of fire, electric hazards and equipment dam-

age, be sure to use only the specified voltage when operating the

PS-A.

WARNINGS

*1 L : AC Input Terminal-live line

N : AC Input Terminal-neutral line

FG : Ground Terminal connected to the PS-A chassis

Insert the power cord (AC inlet plug) into the PS-A's bottom face AC connector.

AC Connector

• The Power Cord included in the PS-A unit’s package is designed only for

AC100V or AC115V use. Any other voltage will require a different cord.

1 2 ... 13 14 15 16 17 18 19 20

No comments

ACTi E66 Installation Guide Page 18