ACTi E66 Installation Guide download pdf (Page 16)

E-16



Removing and Installing the Rear Cover

• Use a screwdriver to loosen or tighten the screws. Be sure not to

tighten screws too tightly, since it may damage the equipment.

• Be careful when removing or installing any screws that they do not

fall inside the PS-A.

Lay the PS-A unit on its side and remove the five (5) cover attachment screws. Slide

the rear cover up to remove it in the direction shown. (When reattaching the screws,

use a torque of 0.5 to 0.6N•m.)



 USB Cable Clamp Installation

This holder prevents the USB cable from becoming disconnected due to vibration, etc.

1) Place the PS-A unit face-down on a flat surface as shown below. Your PS-A unit has two

USB connectors.

• When using only one of the USB ports, be sure to use the lower USB connector.

This allows you to securely clamp the USB cable in the cable clamp.

Upper USB Connecto

Lower USB Connecto

1 2 ... 11 12 13 14 15 16 17 18 19 20

No comments

ACTi E66 Installation Guide Page 16