ACTi E37 User Manual download pdf (Page 6)

www.acti.com

Firmware User’s Manual V6.08.30

Preparation

Connect the Equipment

To be able to connect to the camera firmware from your PC, both the camera and the PC have to

be connected to each other via Ethernet cable. At the same time, the camera has to have its own

power supply. In case of PoE cameras, you can use a PoE Injector or a PoE Switch between the

camera and the PC. The cameras that have the DC power connectors may be powered on by

using a power adaptor.

The Ethernet port LED or Power LED of the caxmera will indicate that the power supply for the

camera works normally.

Configure the IP Addresses

In order to be able to communicate with the camera from your PC, both the camera and the PC

have to be within the same network segment. In most cases, it means that they both should have

very similar IP addresses, where only the last number of the IP address is different from each

other. There are 2 different approaches to IP Address management in Local Area Networks – by

DHCP Server or Manually.

Using DHCP server to assign IP addresses:

If you have connected the computer and the camera into the network that has a DHCP server

running, then you do not need to configure the IP addresses at all – both the camera and the PC

would request a unique IP address from DHCP server automatically. In such case, the camera

will immediately be ready for the access from the PC. The user, however, might not know the IP

address of the camera yet. It is necessary to know the IP address of the camera in other to be

able to access it by using a Web browser.

The quickest way to discover the cameras in the network is to use the simplest network

search, built in the Windows system – just by pressing the “Network” icon, all the cameras of the

local area network will be discovered by Windows thanks to the UPnP function support of our

cameras.

1 2 3 4 5 6 7 8 9 10 11 ... 118 119

No comments

ACTi E37 User Manual Page 6