Bullet Camera Series Hardware Manual D41A, D42A, E42B, E43B, E47 Ver. 2015/03/24
www.acti.com Hardware Manual 10 Item Description 7 Digital Input / Output Connects to digital input or output devices, such as an a
www.acti.com Hardware Manual 11 Mounting Options In areas with fierce weather conditions, the light bundled bracket can be replaced
www.acti.com Hardware Manual 12 Installation Procedures Using the Bundled Bracket Step 1: Install the Bundled Bracket 1. Mark the
www.acti.com Hardware Manual 13 Step 2: Attach the Sunshield The use of sunshield is optional if the camera will be installed indoo
www.acti.com Hardware Manual 14 Step 3: Install the Camera 1. If necessary, install a memory card to the camera. See How to Insert
www.acti.com Hardware Manual 15 Step 4: Waterproof and Connect the Cable The camera and the pre-installed network cable, “pigtail”,
www.acti.com Hardware Manual 16 How to Use the Cable Gland This section describes how to waterproof the cable-out or “pigtail” of t
www.acti.com Hardware Manual 17 2. Insert the clamping nut into the Ethernet cable. 3. Insert the sealing insert with claw.
www.acti.com Hardware Manual 18 6. Connect the Ethernet cable connector to the “pigtail” connector. 7. Attach the gland body to
www.acti.com Hardware Manual 19 How to Use the Conduit Gland This section describes how to waterproof the cable-out or “pigtail” of
www.acti.com Hardware Manual 2 Table of Contents Precautions 4 Safety Instructions ...
www.acti.com Hardware Manual 20 2. Pull the Ethernet cable through the flex conduit. Leave enough length of the cable outside the
www.acti.com Hardware Manual 21 6. On the “pigtail” side, insert the washer into the “pigtail”. 7. Connect the Ethernet cabl
www.acti.com Hardware Manual 22 9. Push the flex conduit and insert the sealing nut into the gland body. NOTE: Make sure the
www.acti.com Hardware Manual 23 Step 5: Connect the Cable Connect the other end of the network cable to a switch or injector. Then,
www.acti.com Hardware Manual 24 Other Connections This section describes the procedures in connecting Digital Input and Output (DI/
www.acti.com Hardware Manual 25 Understanding the DI/DO Cables You can connect up to one (1) DI and one (1) DO device to your camer
www.acti.com Hardware Manual 26 Typical Connection Based on these specifications, if the DI device has a voltage of 0V ~ 30V or the
www.acti.com Hardware Manual 27 The illustration below is a graphic example of connecting a relay to a high voltage DO device. Rel
www.acti.com Hardware Manual 28 Adjustments and Accessories This section describes the procedures on installing a memory card and r
www.acti.com Hardware Manual 29 3. When done, ensure the rubber seal is aligned and attached to the back cover and then close the
www.acti.com Hardware Manual 3 Accessing the Camera 32 Configure the IP Addresses ...
www.acti.com Hardware Manual 30 Adjust the Viewing Angle and Focus The camera already comes pre-focused when taken out of the box.
www.acti.com Hardware Manual 31 How to Reset the Camera In case there is a need to reset the camera to its default factory settings
www.acti.com Hardware Manual 32 Accessing the Camera Configure the IP Addresses In order to be able to communicate with the camera
www.acti.com Hardware Manual 33 If you work with our cameras regularly, then there is even a better way to discover the
www.acti.com Hardware Manual 34 Using the Default Camera IP Address If there is no DHCP server in the given network, the user may h
www.acti.com Hardware Manual 35 Manually adjust the IP addresses of multiple cameras: If there are more than one camera to be used
www.acti.com Hardware Manual 36 Access the Camera Now that the camera and the PC are both having their unique IP addresses and are
www.acti.com Hardware Manual 37 The following examples in this manual are based on Internet Explorer browser in order to cover all
Copyright © 2014, ACTi Corporation All Rights Reserved 7F, No. 1, Alley 20, Lane 407, Sec. 2, Ti-Ding Blvd., Neihu Dis
www.acti.com Hardware Manual 4 Precautions Read these instructions You should read all the safety and operating instructions before
www.acti.com Hardware Manual 5 Federal Communications Commission Statement This equipment has been tested and found to comply with
www.acti.com Hardware Manual 6 Safety Instructions Don’t open the housing of the product Cleaning Disconnect this video product fr
www.acti.com Hardware Manual 7 Introduction List of Models This hardware manual contains the following models: D41A 1MP Bullet wit
www.acti.com Hardware Manual 8 Package Contents Camera Conduit Gland Cable Gland Washer Mounting Screw Kit Sunshield Screw Kit
www.acti.com Hardware Manual 9 Physical Description Item Description 1 Memory Card Slot Insert a memory card (not included) into
Comments to this Manuals