Firmware User’s Manual V6.08.30
28
How to Set and Enable Tours
Once a preset point is created, the Touring Control page tab appears. Click the Touring
Control page tab to configure the Preset Tour. A Preset Tour directs the camera to cycle
through a sequence of preset points and stay on each preset point for a specific time.
To set or modify a tour, do the following:
1. On Select a Preset Point, select a tour and then click Edit Tour.
2. Select a preset point from the list, set the duration (sec) of how long the camera will stay
in that point and the pan/tilt speed (the bigger the number, the faster the speed), and then
click .
3. On the Preset Points, the preset points added to the Tour are listed.
To change the sequence of preset points, click the (first / up /
down / last) icons.
Comments to this Manuals