ACTi D72 Manual download pdf (Page 13)

www.acti.com

Hardware Manual

Installing the Camera on a Surface

This section describes the procedures in installing the camera on a flat surface such as a hard or

dropped ceiling and straight or tilted walls.

Step 1: Drill the Holes

1. Using the supplied drill template, mark the screw holes location on the surface, then drill the

holes and insert the plastic plugs.

2. Determine how the cables will be routed: pass through the surface or along the surface.

 If the cables will pass through the surface:

a. Mark and drill the conduit hole location on the surface as shown on the drill

template.

b. Remove the metal cap covering the bottom conduit hole of the camera, and

attach the cap to the side conduit hole to close it. Route the network cable to

pass this hole from the surface.

 If the cables will be routed along the surface, skip to the next step.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

No comments

ACTi D72 Manual Page 13