Firmware User’s Manual V6.08.30
66
Motion Detection
The section “Motion Detection” allows the user to configure the video motion
detection system of the camera. Motion detection regions are based on Stream 1. By default,
there are three (3) enabled pre-defined regions covering the whole camera view.
Click on “Setup” to adjust the motion detection regions or its parameters. Microsoft Internet
Explorer browser is required to configure the motion detection regions.
There are three independently configurable motion detection regions in the camera. Each
motion detection region has 6 configuration parameters:
Enabled or disabled
Location of the region
Size of the region
Sensitivity
Trigger threshold
Trigger interval
Comments to this Manuals