ACTi D41A Manual download pdf (Page 26)

www.acti.com

Hardware Manual

Typical Connection

Based on these specifications, if the DI device has a voltage of 0V ~ 30V or the DO device has

a voltage of < 24V (< 50mA), then the camera can supply internal power to these devices and

there is no need to connect the DI/DO device to an external power source.

In this case, wire connection to Pins 1 to 4. Use the DIO GND and DI pins to connect a DI

device and use the DIO PW and DO pins to connect a DO device. See wiring scheme below:

High Voltage DO Device Connection

Even though the camera provides 12V power, this may not be enough for some high voltage

DO devices, such as a ceiling light or a motor that opens or closes a gate. In this case, there is

a need to connect an external relay. See wiring scheme below:

Note that when choosing an appropriate relay, please refer to its specifications and make sure

they match the above design. The triggering circuit voltage has to be around 12V DC and the

switch-controlled circuit voltage has to match the external power supply (e.g. 110V AC or 220V

AC).

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 37 38

No comments

ACTi D41A Manual Page 26