ACTi D41A Manual download pdf (Page 31)

www.acti.com

Hardware Manual

How to Reset the Camera

In case there is a need to reset the camera to its default factory settings, do the following

procedures while the camera is powered on.

1. Loosen the three (3) screws securing the back cover.

NOTE: A cable is connected inside the camera; do not abruptly pull the back cover.

2. Using a pointed object, such as the tip of a pen, press and hold the Reset button for at

least 5 seconds or until the Power LED lights up, to reset the camera.

3. When done, ensure the rubber seal is aligned and attached to the back cover and then

close the back cover by tightening the three (3) screws.

CAUTION: Make sure the rubber seal is properly attached and the back cover is closed to

ensure water or dust cannot enter the camera.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 37 38

No comments

ACTi D41A Manual Page 31