ACTi B27 Manual download pdf (Page 13)

Hardware Manual

Before Installation

This section describes the procedures in preparing the external devices that you can connect to

the camera. The camera supports DC12V power input, Digital Input and Output (DI/DO), Audio

Input and Output devices, as well as Serial Devices like a Pan-Tilt (PT) Scanner using the

bundled terminal blocks. The use of these devices, however, is optional.

Connecting a Power Adapter (Optional)

In case of using a non-PoE switch or your PoE switch has limited power supply, you can

purchase a power adapter and directly connect the camera to a power outlet. The power adapter

must be connected to the supplied terminal block before use.

To do this, follow the procedures below:

1. Loosen the screws of the 12V and GND pins of the power terminal block.

2. Take note that a standard power adapter cable has two (2) different wires:

White stripe: Connects to 12V Pin

Connects to GND Pin

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 32 33

No comments

ACTi B27 Manual Page 13