ACTi GNR-3000 User Manual download pdf (Page 86)

www.acti.com

GNR-3000 System Administrator’s Manual

Set PTZ Command

If your speed dome or PTZ device has a special function not supported in the standard

protocol, you may input it in PTZ Command list and execute it. Ex: Activate the wiper to clean

the window of the PTZ.

1. To add a PTZ action command, go to Setup page 

Devices tab, select the device from Device List, on

PTZ tab, check the “Enable PTZ”.

2. In “PTZ Command” area, click in a command entry;

input the name, command and then click “Apply” to save it. You may also click “” to

execute it or “X” to clear it.

Set PTZ Preset Tour

Preset Tour is a preconfigured PTZ sequence that directs the camera to cycle through multiple

preset points, including where to look and how long to look at each location. With this preset

tour, your PTZ device can perform an automatic patrol to scan through your cared areas.

For example, a Preset Tour should include two or more preset points. Once a tour is initiated,

the device will automatically point to the preset points based on the sequence and stay at that

view according to the duration you set.

Before setting up Preset Tours, please make sure you have configured PTZ settings and set

PTZ Preset Points. To start setting the Preset Tour:

1. Go to Setup page Devices tab, select the device from Device List, and click Preset

Tour tab.

2. In the “Tour List”, as there is currently no existing tour, click “Add New Tour” to add one.

The default tour name is “Preset Tour 1”.

3. In the “Preset Points of a Tour” area, click “Add Preset Point” to add the number of

points for this tour. The number of points may outnumber the actual preset points you set,

for the same preset point might be gone through more than one time in a single tour. For

each point, click in the “Preset Point” field to bring up the dropdown list, and select one

preset point and define the dwell time which represents the time the device would stay in a

certain view. Finally, click “Apply” to save the tour.

Preset Point 1

Preset Point 2

Preset Point 3

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 149 150

No comments

ACTi GNR-3000 User Manual Page 86