ACTi I51 User Manual download pdf (Page 70)

www.acti.com

Firmware User’s Manual V6.08.30

There is one more item on the Motion Detection configuration

page which was not explained above – the Profile of Motion

Detection. Think of them as Profile 1 (Runtime MD Profile) and

Profile 2 (Event MD Profile). It means that you can configure

two independent groups of Motion Detection regions with at most 3 regions in each group.

Normally, the Profile 1 (Runtime MD Profile) is used as an active profile of the camera. However,

in some cases it is possible to let the camera switch to Profile 2 by using the Event Handler

system of the camera.

For example, you might want to have different motion detection parameters for day and night time.

Then the two profiles become really handy. In such case, remember to configure the motion

detection parameters for both profiles before moving on to configure the event response system.

After changing any of the items above, press Apply to save the changes. The Reset button

undoes the changes that had just been made but not Applied yet.

NOTE: For PTZ / Speed dome cameras, it is recommended to turn off motion detection when

scan and tour modes are enabled to avoid false motion alarm.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 118 119

No comments

ACTi I51 User Manual Page 70