ACTi I51 User Manual download pdf (Page 100)

www.acti.com

Firmware User’s Manual V6.08.30

100

Change Motion Detection profile: This will switch the profile of the selected Motion Detection

region from Runtime profile to Event profile. The profile will return to runtime settings at the end of

this event. You may program one motion detection region to be disabled at runtime, but enable it

with event handler under some circumstances.

Send URL command: Select the URL command to include in the response set. Two different

commands will be sent at the time when the event is triggered and un-triggered. For example,

going to a preset point, if the device is a PTZ camera, and there are preset points already

configured in PTZ setup page, then you may include this in the response section of the event rule

by using Send URL Command method. It is possible to let the camera return to another preset

point at the end of the event.

Change to Day / Night Mode (Selected models only): For some models, you may force the

Camera into Day or Night mode. The camera will return to its previous setting (whether auto or

forced day/ night) upon the end of the event.

After changing any of the items above, press Apply to save the changes. The Reset button

undoes the changes that had just been made but not Applied yet.

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 118 119

No comments

ACTi I51 User Manual Page 100