Hardware Manual
14
Step 4: Waterproof and Connect the Cable
If the camera will be installed indoors, simply connect the network side cable to the camera
Ethernet port. No need to waterproof the cable connection. However, if the camera will be
installed outdoors, check the type of Ethernet port and follow the applicable procedures to
waterproof the cable connection.
There are three (3) ways to manage and waterproof
the square-shaped “pigtail”:
Using the Waterproof Tape, see page 15.
Using the Bundled Conduit Gland, see page
16. A flexible conduit (trade size ½”) is required to
house the Ethernet cable.
Replacing the Pre-Installed Square-Shaped ,
see page 21.
Comments to this Manuals