ACTi D42 User Manual download pdf (Page 16)

www.acti.com

Firmware User’s Manual V6.03.17

Host

The section “Host” allows the administrator to define the name of the

camera and preferred user interface language.

There are two kinds of names – Host Name and Camera Name.

Host Name is used to identify the camera by a DHCP server. In some networks with very strict

security policy, it is required that all the network devices should have their host name, and when

the devices attempt to access the network by requesting an IP address from a DHCP server, the

DHCP server would check if the host name is among the allowed devices. On this page, it is

possible to edit the Host Name. To actually include the Host Name in DHCP discovery packet

sent from a camera, please go to IP Settings and make sure the device is in Dynamic IP

Address mode and “Use host name” is checked.

Camera Name is used to identify the device by Video Management System or by Software

Tools. Usually, upon installation of the camera, the actual installation location is used as an

easy-to-remember Camera Name, such as “Front Gate” or “Elevator 1”. In many cases the VMS

is able to modify the Camera Name directly via its own user interface without needing to access

Web Configurator.

Language selection under Host has the same purpose as the one on the login page of Web

Configurator.

After changing any of the items above, press Apply to save the changes. The Reset button

undoes the changes that had just been made but not Applied yet.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 76 77

No comments

ACTi D42 User Manual Page 16