ACTi KCM-5311 User Manual download pdf (Page 20)

www.acti.com

Firmware User’s Manual V5.01.07

Parameters

Description

IP address

filter enable

Check this box to enable IP Address Filtering.

Filter Method

The filter can be set in either “Allow” mode or “Block” mode.

1. “Allow” mode will refuse access to all IP addresses except the ones

listed below.

2. “Block” mode will accept all incoming access except the IP

addresses listed below.

Make sure you include the Netmask in your consideration.

IP Address

The IP address you wish to allow or block. Please note that the actual

range is modified by the Netmask.

Netmask

Using Netmask allows you to set filtering for a whole range of IP address

at once, without the need to enter all of them individually. If you are not

sure about the function of netmask, then you should use

255.255.255.255, and it will affect only a single IP address per line of

entry, or use 255.255.255.0 to use the same setting for all IP addresses

starting with the same three numbers. .

Enable

For each entry, you must check this box for it to be effective. For an entry

that you no longer need but does not wish to delete, you can uncheck it,

and the system will remember it for future use. If a new entry that has

never been used before does not have Enable checked, then it will not be

stored in memory.

Apply

Click this to use the current displayed info to do IP Address filtering. If you

setup correctly, it will change into a grayed out “Success” in a few

seconds.

Reset

Click this button to re-enter the parameters.

Click the [Apply] button to confirm the settings or click the [Reset] button to re-enter the

parameters.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 49 50

No comments

ACTi KCM-5311 User Manual Page 20